mercedes-benz Unimog Model Series 405 — UGE_Euro6_en.pdf

Overview Hydraulic components Power hydraulics (circuit III and IV) The power hydraulics allow rotating consumers to be powe- red (e.g. cutting roller, wood chipper etc.). Both circuits are designed as open circuits with a maximum volumetric flow rate of 125 l/min each at a maximum of 280 bar. Code HL4 includes one circuit while code HL5 includes two power hyd- raulics circuits. • The power hydraulics are located in the platform interme- diate frame and can be quickly removed if they are not required e.g. during winter service operations in order to increase the payload. As a result, the connections are no longer in the vehicle center but at the vehicle rear.

• In addition to the rear connections, front connections are also possible for both circuits (including simultaneously) with code H93 and H94. b b Note All of the aforementioned volumetric flow rate and pressure specifications are maximum values, which are only available at the corresponding engine speed and may not be available permanently. Overview of hydraulic components G55.00-3169-00 Introduction of the New Unimog Generation | Model Series 405 39 – This printout will not be recorded by the update service. Status: 03 / 2013 –