mercedes-benz Unimog Model Series 405 — UGE_Euro6_en.pdf

Hydraulic components Overview The hydraulic system of the Unimog can be made up of the following components. • Fan hydraulics • Tilting hydraulics • Work hydraulics • Power hydraulics Working/municipal hydraulics (circuit I and circuit II) The working hydraulics allow an implement to be adjusted or a permanent consumer to be supplied. On the 1-circuit hydraulic system one circuit is available for this, while on the 2-circuit hydraulic system, two independent circuits are available, each with its own fixed displacement pump. This allows adjustment operations to be carried out and a permanent consumer to be supplied simultaneously.

On the 2-circuit hydraulic system, the volumetric flow rates can be swapped over via the volume switchover function or added together via flow summation. Fan hydraulics The fan hydraulics are included in the basic scope of all ve- hicles. Fan hydraulics are only available to body manufactur- ers with code HE2. Actuation of tilt cylinders • On vehicles without work hydraulics, the tilt cylinder is ac- tuated on a simple on/off basis via a button in the cab. • On vehicles with work hydraulics (code HN2/HN4/HN6/ HN7/HN8), the tilt cylinder is actuated proportionally via the vehicle joystick. Changes compared to the hydraulic system of Euro V vehicles:

• Fully proportional working hydraulics at connections of cells 1–4 (connections 1-8) • Integrated pressure and return filter • Control of consumers during adjustment operations via the vehicle joystick (social distribution) with diagonal mo- vement of vehicle joystick. • Hydraulic connection possibility on distributor block un- derneath PTO transmission (e.g. for roll stabilization) • Electrical interface for actuation of hydraulic valve block (circuit I) e.g.

for external actuation of front and/or rear power lift • Joystick with rocker switch for forward/reverse shifting of manual vehicle transmission B B Important The vehicle tilt cylinder is connected to the valve block (code HE1/ HE2 (EQR)) of the tilt hydraulics (independently of the work hydraulics). With this new hydraulic arrangement, it is possible to order a vehicle with tilting hydraulics even without work hydraulics. b b Note Due to the omission of link motion, two adjust- ment operations can be carried out simultane- ously. Example: Raise front loader and tilt shovel simultaneously.

38 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –