mercedes-benz Unimog Model Series 405 — UGE_Euro6_en.pdf

Design New hydrostatic drive Control unit The algorithm for control of the hydrostatic drive is integrated in the ICM virtual control unit (Implement Carrier Module). The ICM runs on the physical STCU (Special Trucks Control Unit). It is diagnosis-capable, parameterizable and flashable, which allows troubleshooting using Star Diagnosis in the workshop. An operating hours counter can be accessed on the Instrument. A control joystick can be installed on the center console, which is connected to the STCU via CAN, and is evaluated in the ICM for actuation of the hydraulic compo- nents and the new hydrostatic drive.

An additional lever in the form of a cruise control lever can be installed on the left of the steering column assembly above the turn signal lever. This lever is also connected to the STCU and is evaluated in the ICM to control the transmission, cruise control and travel direction. Transmission with hydrostatic drive G55.90-3169-00 2) Variable displacement motor 1) Variable displacement pump 3) Oil filter 4) Intermediate transmission 5) Manual transmission Introduction of the New Unimog Generation | Model Series 405 37 – This printout will not be recorded by the update service. Status: 03 / 2013 –