New hydrostatic drive Design Hydraulic pump A variable displacement and switchable swash plate axial piston pump of 55 cmі is used. The rotation direction of the pump drive is clockwise. It is mounted via an SAE-C mounting flange with an ANSI B92.1 drive shaft with 21 teeth. The low- pressure circuit is supplied with 24 bar by an integrated feed pump. The pump displacement is varied in a pressure range of 4 -16 bar from 0 cmі to 55 cmі. The actuating pressure is controlled on a linear basis with a 24 V proportioning valve for each direction, ranging from 225 mA - 4 bar to 600 mA - 16 bar. The pump does not feature an internal mechanical pressure cutoff function.
Dog clutches and reversing group The dog clutches for the new hydrostatic drive are operated pneumatically by a separate 3/2-way valve actuated by the ICM. The reversing group is actuated pneumatically by the transmission control system (TCM) via 3 separate 3/2-way valves. This allows the reversing group and hydraulic as- semblies to be switched independently, which allows rapid switching between the manual transmission and hydrostatic transmission. The condition of each dog clutch is read in se- parately by the ICM via separate cam switches. Cooling A temperature sensor which senses the oil temperature of the hydrostatic drive is connected to the STCU.
As of 70 °C, a fan is activated via a relay connected to the STCU and is shut off again at 60 °C. If the temperature exceeds 80 °C, a warning is output on the Instrument. If the temperature does not drop, the adjustable maximum pressure is gradually limited to reduce the power output capability of the major assembly. High-pressure circuit pressure sensors Pressure sensors are used at both measuring connections of the hydraulic pump (forward and reverse high-pressure cir- cuit). Measuring range 0-600 bar, connection stud M14x1.5 DIN 3852 with sealing ring. Power supply 5 V, ratiometric voltage output 10% - 0 bar - 0.5 V, 90% - 600 bar - 4.5 V.
Hydraulic motor A variable displacement swash plate axial piston pump of 75 cmі is used. It is mounted via an SAE-C mounting flange with an ANSI B92.1 drive shaft with 21 teeth. The low-pressure circuit is supplied by the integrated feed pump of the hydro- stat pump. The motor displacement is varied in a pressure range of 4 - 16 bar from 0 cmі to 75 cmі. The actuating pressure is controlled on a linear basis with a 24 V proportio- ning valve, ranging from 225 mA - 4 bar to 600 mA - 16 bar. When deenergized, the major assembly swivels to the zero position. No delayed adjustment nozzles are installed in the low-pressure circuit to improve controllability.
36 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –