mercedes-benz Unimog Model Series 405 — UGE_Euro6_en.pdf

System components New hydrostatic drive The components are arranged sequentially: friction clutch, transmission. In the transmission, the direction of rotation of the engine can be inverted via the reversing group by means of a switchable gear set and the torque can be transferred via the countershaft to the main transmission. In the process, power is transmitted by the gears with an efficiency of > 0.9. In a third position (neutral position), the torque of the engine can be diverted to a hydraulic pump via a dog clutch. An oil volume can be steplessly transferred to the hydraulic motor in both directions via the closed high-pressure circuit.

Through the use of hydraulic assemblies which can be electri- cally adjusted to zero output, it is possible to interrupt power transmission to allow engagement/disengagement and shif- ting of transmission stages while driving. By simultaneously reducing the volumes of the hydraulic pump and hydraulic motor on a proportional (ratiometric) basis, it is possible to interrupt the power transmission of the hydraulic assembly without changing the gear ratio. Measuring the high pressure allows the transmission to be shifted into an unpowered state at the optimal time. Ope- ning the drive clutch allows the hydraulic assemblies to be completely shut off while driving by means of dog clutches.

The pressure control system in the high-pressure circuit allows the hydraulic assemblies to be adjusted for optimal performance. The hydraulic motor draws in the oil volume from the pump hydrostatically and transfers the resulting torque to the coun- tershaft via an additional dog clutch and thus to the main transmission when a gear is engaged. A variable gear ratio for rpm and torque is produced by adjusting the volumes in the pump and motor. As a result of mechanical and volumetric losses, the resulting efficiency levels are lower, ranging from 0.4 to 0.7. 35 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status:

03 / 2013 –