New hydrostatic drive Overview Work transmission mode During working operations, this transmission mode allows the vehicle speed to be adjusted independently of the engine speed. The vehicle speed can, if necessary, be regulated using the work mode cruise control function within a range of 0.1 km/h to 25.0 km/h, allowing the vehicle to be driven without using the accelerator pedal. Gear changes can also be initi- ated manually using the controls while driving. The system is limited to 6th gear and a speed of 50 km/h. Changing between the new hydrostatic drive and transmission The new hydrostatic drive can be deactivated while driving by pressing the system button on the center console.
On EPS vehicles or EAS vehicles with the clutch pedal folded out, the clutch must be also be operated manually. If the new hydrostatic drive has been shut off in this manner (the LED in the system button is no longer on), the new hydrostatic drive can then only be activated again using the system button with the vehicle at a standstill. Only on EAS vehicles with the clutch pedal folded in is it possible to put the new hydrostatic drive into standby mode while driving and switch to a limited mechanical drive mode. This is triggered in Work or Drive by pressing the accelerator pedal past the pressure point (kick- down).
The new hydrostatic drive remains in standby mode (LED in system button flashes), while the vehicle is driven by the transmission with automatic gear changes. The mode "H drive" is shown on the display. During coasting, the system automatically switches to the new hydrostatic drive so that the vehicle is always started off hydrostatically. The start-off gear used for this can be selected with the vehicle at a stand- still (gear 1-6). When the new hydrostatic drive is in standby mode, 8th gear is disabled to prevent driving at maximum speed. This is intended to prevent increased consumption over extended periods.
If the driver wants to drive at full speed, he/she has to switch off the new hydrostatic drive using the system button. Drive transmission mode This mode is used for automotive-style driving using the hy- drostatic drive. Starting from an increased idle speed (900 rpm), the engine speed is regulated depending on the vehicle speed and accelerator pedal. On vehicles with EPS and EAS, gear changes can be initiated automatically or manually as desired (change via extended actuation of A/M mode but- ton on the right multifunction control lever). The system is limited to 6th gear and a speed of 50 km/h as long as the hydrostatic drive is activated.
When changing from Drive to Work (using the A/M mode button on the right multifunction control lever), the last working speed active in Work (within an ignition cycle) is automatically restored and the last active gear is engaged (provided that engagement conditions are met within 15 s). When changing from Work to Drive, the start-off gear stored for Drive is engaged with the vehicle at a standstill. 34 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –