Networking Central gateway (CGW) The central gateway (CGW) is a component of the vehicle architecture. As a result, its functions are determined and defined by this architecture. All CANs connected to the CGW have a wake-up function. The CGW wakes up all of the buses if a message is sent on one bus. The CGW only allows the buses to sleep when all connected buses indicate that they are ready to sleep i.e. the CGW syn- chronizes the sleep process. The following virtual control units are integrated in the CGW: • Central Data Memory (ZDS) • Maintenance system (WS) • Communication module (COM) It incorporates the following functions:
• It routes messages and signals between various CAN bu- ses (function gateway) • It can route messages and signals from an entire SUB- CAN for diagnosis purposes! This function is called the "application gateway". • It is responsible for the timing of sleep and wake-up com- mands for the connected CAN buses (part of the power management system) • It provides the interface for the external diagnostic tester (diagnosis gateway) • It monitors the remaining control units for failure • Information describing the vehicle is parameterized cen- trally in the CGW and, together with the list of installed control units, is made available to other control units by the CGW through cyclical CAN messages.
K-lines are no longer used. The CGW monitors all control units except itself for failure and the CGW is monitored by the ICUC. All messages from each control unit are monitored, not just one. B B Important Do not exchange control units within a vehicle or across different vehicles. Otherwise, they will receive fault messages or the terminal control function may be disabled, rendering the ignition lock nonfunctional. In this case, contact a Mercedes-Benz Service Center. 72 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –