Control unit network Networking Control unit network The MUX system, which is used in the Unimog and other Mercedes-Benz vehicles, as a control unit network consis- ting of several control units. Depending on the configuration and output, loads of up to 10 A can be switched with it. The integrated overload protection function for each output also makes the use of external fuses unnecessary. The control unit network is mainly used to implement the basic electrical functions of the vehicle e.g.:
• Terminal control • Exterior lights • Interior lights • Differential lock • Horn • 24V trailer socket • Wiping/washing • Various other functions Setup in vehicle Each vehicle requires more output and inputs than are availa- ble in one control unit of the control unit network and, as a result, not just one control unit is installed here. On the Uni- mog, three control units are used per vehicle. The particular specialty of the control unit network is its abi- lity to function as a network linked via CAN bus. Due to this networking, all outputs of one control unit of the control unit network can also be actuated by another control unit of the control unit network.
This architecture provides the maximum level of scalability and flexibility. b b Note The three control units of the control unit network have identical hardware components and the control units therefore look identical. When removing and reinstalling these control units, make sure that they are reinstalled in their original position. b b Note Terminal signals and other signals (e.g. lighting sig- nals) are made available to body manufacturers via an interface. Tapping the signals directly at a control unit is to be avoided. 71 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –