Maintenance Maintenance Maintenance service Refer to the respective valid maintenance sheet and the con- tent of the individual maintenance items for the maintenance scope. Perform safety-relevant maintenance work according to the national legislation; but at least once a year if no ins- pections according to law are planned within a year. The additional operations are combined accordingly on the maintenance sheet and separated by corresponding hea- dings: • V2 = Adjust valve clearance at 2800 Bh, 5600 Bh, 8400 Bh, 11,200 Bh etc.
• ZX = Additional operations at every 3rd engine oil change • Z2 = Additional operations every 2 years • Z3 = Additional operations every 3 years • Z4 = Additional operations every 4 years • Z6 = Additional operations every 6 years • J1 = Work relevant to safety once a year, subject to sepa- rate repair order The completion of the individual maintenance items must be recorded by entering a cross in the boxes in front of the ope- ration titles. A cross should be entered in the boxes after the operation titles to identify items which were not OK when the vehicle was received.
Confirmation for this is provided by the mechanic by entering his/her signature in the header section of the maintenance sheet. The maintenance operations to be carried out must be marked with a cross by the service advisor in the fields provi- ded in the top part of the maintenance sheet. The time-dependent maintenance operations and the additi- onal operations for the maintenance service and are marked on the maintenance sheet in front of the relevant operation item with: • A = Maintenance at 200 Bh • B = Maintenance at 1400 Bh, 4200 Bh, 7000 Bh, 9800 Bh, 12,600 Bh etc. • C = Maintenance at 2800 Bh, 5600 Bh, 8400 Bh, 11,200 Bh, 14,000 Bh etc.
83 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –