Maintenance Diagnosis Diagnosis The diagnosis functions of the control units are primarily intended to ensure that the corresponding systems operate properly. This takes place through ongoing checking of whe- ther the sensors connected to a control unit supply plausible values. The diagnostic data can also be used for troubleshoo- ting. The UDS (Unified Diagnostic-Services) diagnosis proto- col, which is also used in the passenger car sector, is used for data transfer purposes. On-Board Diagnosis (OBD) OBD is used to monitor and diagnose all systems which affect exhaust emissions. It is a legal requirement.
Malfunc- tions and faults which occur are displayed to the driver via an indicator lamp and stored in the fault memory. These can be read out using Star Diagnosis. The stricter regulations of OBD 2 apply to the Euro VI stan- dard. The OBD-NOx-Control system also monitors, for ex- ample, the quantity of nitrogen oxide (NOx) and particulate matter (PM) emissions. If the limits are exceeded, the OBD- NOx-Control system informs the driver and takes action e.g. actuation of the MIL (Malfunction Indicator Lamp) or, in the most extreme case, torque reduction. Compared to the predecessor model, the diagnosis routines for service have been significantly optimized.
This is particu- larly noticeable in the speed of communication with control units and, furthermore, multiple control units can transmit and receive simultaneously. When a control unit is flashed, communication between con- trol units is interrupted in order to free up the CAN line. This shortens the flashing time from approx. 30 min to approx. 3 min. Faults which occur can also be read out on the inst- rument cluster. The advantage of this is that the driver can read out the faults and inform the workshop in advance about which faults are occurring. 86 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status: 03 / 2013 –