Operating fluids Maintenance The quality of oil used has a massive influence on the service life of a major assembly and you should therefore only use operating fluids which comply with the Mercedes-Benz Speci- fications for Operating Fluids. The sulfur content of the fuel also has an effect on the ser- vice life of the engine. The sulfur content of the fuel can be set to three stages using the on-board computer. Engine oil Engines 934.9 and 936.9 may only be operated with engine oil in accordance with sheet 228.51 (Low SPAsh multigrade service engine oils) of the Mercedes-Benz Specifications for Operating Fluids.
• 0 – 0.05 % sulfur content = factor 1 • 0.05 – 0.1 % sulfur content = factor 0.5 • > 0.1 % sulfur content = factor 0.3 Roughly 2 weeks before a service is due, the driver is infor- med about this via a pop-up message when the ignition is switched on. The next warning stage appears with the mes- sage "Service immediately". All of the displayed messages are stored in the memory so that, in the event of complaints, it is possible to determine when each message was displayed. B B Warning: Operation with biodiesel (fatty acid methyl ester) is not permissible. 85 Introduction of the New Unimog Generation | Model Series 405 – This printout will not be recorded by the update service. Status:
03 / 2013 –