ELECTRONIC CONTROL SYSTEM RIGHT BANK INJECTORS X1 X2 X1 X2 LEFT BANK INJECTORS CMPO X3-10 CKPO X3-5 X3 X3 CKP (+) X1-1 X1 X2 X1 X2 CKP (-) X1-2 CMP (+) X1-9 X3 X4 X3 X4 CMP (-) X1-10 CKPO X1-19 IDM CRANKSHAFT POSITION SENSOR CMPO X1-24 ECM 1 2 + CAMSHAFT POSITION SENSOR - + 1 2 - Magnetic Pick-Up Sensors The Camshaft Position (CMP) sensor and Crankshaft Position (CKP) sensor are both magnetic pick-up type sensors. Each sensor contains a permanent magnet core surrounded by a coil of wire. The sensor generates a signal through the collapse of a magnetic field created by a moving metal trigger. Movement of the trigger induces an Alternating Current (AC) voltage in the sensor coil.
The ECM uses the AC signal to determine the position of the camshaft. The ECM converts the AC signal to a square wave output. The output signal, Camshaft Position Output (CMPO), is sent to the IDM for fueling calculations. The ECM conditions the CMP signal and sends it out as the TACH signal for body builder use. The ECM uses the CKP signal to determine the position and speed of the crankshaft. The ECM converts the AC signal to a square wave output, Crankshaft Position Output (CKPO), and sends it to the IDM for fueling calculations. The ECM needs both the CKP and CMP signals to calculate engine speed and crankshaft position.
From the CKP signal the ECM can determine the speed of the crankshaft and the position of each piston relative to Top Dead Center. From the CMP sensor the ECM can determine the current stroke of each (i.e., compression or exhaust). Crankshaft Position (CKP) Sensor The CKP sensor is mounted on the right front of the lower crankcase. The CKP sensor reacts to a sixty- minus-two tooth trigger wheel affixed to the front of the crankshaft. The sensor produces pulses for each of the 58 teeth as they pass the magnet. The two tooth gap allows the ECM to calculate the position of the crankshaft. Camshaft Position (CMP) Sensor The CMP sensor is mounted on the left front of the crankcase.
The CMP sensor reacts to a single peg pressed into the camshaft. The peg passes the sensor once per camshaft revolution producing an AC signal in the coil. 31 International ® VT 275 V6 Engine