ELECTRONIC CONTROL SYSTEM X1 X2 X1 X2 X1-17 GPC X1-21 GPD X3 X4 X3 X4 GLOW PLUGS BAP ECM ECT BATTERY 200 A GPC GPD 1 3 5 N.O. TERMINAL STARTER IAH IAH RELAY GLOW PLUG RELAY 4 12-WAY ENGINE TO CHASSIS CONNECTOR Glow Plug System • The VT 275 uses glow plugs to aid cold starts. The ECM turns on the glow plugs prior to engine cranking to increase the temperature of the cylinders. Glow plug operation is controlled by the ECM through the glow plug relay. The glow plugs have full voltage if battery voltage is normal, or pulse width modulated to control the current if battery voltage is above normal.
Relay Operation The glow plug relay receives battery voltage to its common terminal from the starter power-feed terminal. The normally open terminal connects to the individual glow plugs through the glow plug harness. One end of the relay coil is always grounded through pin 4 of the engine 12-way connector. The ECM supplies 12 volts to the other end of the coil through ECM pin X1-17 in order to close the relay contacts. Both lamp operation and the glow plug operation are based on BAP and ECT values but are independ- ent of each other. The glow plug operation may continue after the lamp is off.
Glow Plug Diagnostics Glow plug diagnostics are used to determine if the relay is operating correctly when commanded on. An additional wire on the relay's normally open terminal connects to ECM pin X1-21. This circuit, GPD, allows the ECM to monitor the relay operation. The ECM calculates glow plug on- time based on coolant temperature and barometric pressure. The required time to warm up the cylinders decreases as engine coolant temperature increases. Warm up time decreases as barometric air pressure increases. The glow plugs may continue to be energized after start-up to reduce emissions. Glow Plug Lamp The glow plug lamp is used as a wait-to-start indicator.
The ECM lights the glow plug lamp at glow plug activation to signal the operator to wait for the cylinders to warm up. The glow plugs can be turned on using the KOEO Glow Plug/Inlet Air Heater Test. The test can only be activated twice per key cycle. 32 International ® VT 275 V6 Engine 2 4 6