International Trucks VT 275 — VT275 manual

ELECTRONIC CONTROL SYSTEM X1 X2 X1 X2 X1-18 IAHC X2-11 IAHD MAF / IAT X3 X4 X3 X4 BAP ECM EOT BATTERY 200 A IAHC IAHD N.O. TERMINAL STARTER IAH IAH RELAY 4 12-WAY ENGINE TO CHASSIS CONNECTOR Inlet Air Heater Operation • The VT 275 has an Inlet Air Heater (IAH) element mounted in the front of the intake manifold. The IAH is used to improve cold start operation, reduce emissions and white smoke, and improve engine warm-up. When the key is ON, the ECM determines if the element should be activated and for how long, based on barometric pressure and engine oil temperature. On time is limited to prevent heater element damage and to prevent damage to the intake manifold.

The heater relay delivers full voltage to the element if battery voltage is normal, or the relay is pulsed by the ECM to control the current if battery voltage is above normal. If the battery voltage is so low that the starter motor operation may be affected, the inlet air heater is disabled. Inlet Air Heater Diagnostics An additional wire on the normally open terminal connects to ECM pin X2-11. This diagnostic circuit allows the ECM to determine if the IAH relay is on when commanded on by the ECM. Relay Operation The IAH relay receives battery power from the starter power feed terminal. The normally open terminal connects to the element through the harness.

One end of the relay coil is always grounded through pin 4 of the engine 12-way connector. The other end of the coil receives 12 volts from ECM pin X1-18 to close the relay contacts. The Inlet Air Heater can be turned on using the KOEO Glow Plug/Inlet Air Heater Test. The test can only be activated twice per key cycle. The ECM will delay the Inlet Air Heater operation for three seconds after the test is activated. 33 International ® VT 275 V6 Engine