International Trucks VT 275 — VT275 manual

ELECTRONIC CONTROL SYSTEM X1 X2 X1 X2 PDC# Device F11 F19 20A...FUEL PUMP 20A...FUEL HEATER X3 X4 X3 X4 X4-15 FPM X3-1 WIF X3-9 FPC ECM PDC 2 5 FUEL PUMP RELAY TO IGNITION POWER 3 1 HFCM TO RUN / ACC RELAY F11 BATTERY 200 A F19 2 5 PUMP FUEL HEATER RELAY TO KEY SWITCH 3 1 GRD Pump Operation • The VT 275 has an ECM controlled chassis mounted electric fuel pump. At key-on, the ECM will operate the fuel pump for up to 60 seconds to prime the system. Priming allows the pump to pressurize the system and to allow air in the system to bleed out through an orifice between the filter housing and the fuel return circuit.

Circuit Operation To operate the pump, the ECM provides a ground at ECM pin X3-9 to latch the fuel pump relay. The relay takes power from fuse F11 and provides it to pin 1 of the pump connector. The ECM monitors the relay's operation through ECM pin X4-15. Battery voltage should be present at X4-15 when the relay is commanded on. If the ECM does not detect the voltage, a DTC will be logged. Water-In-Fuel Sensor The pump module contains a Water-In-Fuel (WIF) sensor. The WIF sensor receives voltage from the key switch. If the filter detects water, the sensor sends the voltage to ECM pin X3-1. The ECM then activates the dash WIF lamp.

When the engine is in run mode, the pump will operate continuously. If the engine dies or is shut down, or if it is not started within 60 sec- onds, the ECM will stop the pump. Fuel Heater The Horizontal Fuel Conditioning Module (HFCM) contains a fuel heater. When the key is ON, the fuel heater relay latches and provides power to pin 1 of the heater connector. The heater element contains a thermostat that controls the heater operation. 35 International ® VT 275 V6 Engine 1 2 2 1 2 1