International Trucks VT 275 — VT275 manual

ELECTRONIC CONTROL SYSTEM EGR DRIVE MODULE POWER GRD ECM POWER X3 X1 X1 X2-13 X3-31 X1 X2 X1 X2 GRD X2 X2 X2-6 X3-30 X3 5 2 3 4 1 6 7 8 W V U X3 X4 X3 X4 X2-12 SHD IDM S N N N S S 16 SENSOR GRD POSITION SENSOR W POSITION SENSOR V POSITION SENSOR U SENSOR 5V SUPPLY 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 EGR VALVE EGR VALVE EGR DRIVE MODULE SHIELD DRAIN MOTOR W MOTOR V MOTOR U TO FRAME GROUND 10 CAN2- CAN2+ GRD ACT PWR TO ECM RELAY ‘NORMALLY OPEN’ TERMINAL 4 ENGINE IN-LINE RELAY EGR System The motor-actuated EGR valve is controlled and monitored by the EGR Drive Module. The module is connected to the engine CAN 2 link allowing bi-directional communica- tion with the ECM.

Two coil sets are powered together to reposition the motor, with one set connected to power and the other to ground. Each powered coil set creates either a north or a south magnetic field depending on the direction of current flow through the coils. The drive module constantly switches the coil sets (identified as Motor W, V, and U) from power and ground to continually produce rotation. Pulse width modulation is used to control the current. Communication Three Hall-Effect sensors are located on a circuit board at the top of the valve housing.

The sensors are supplied power and ground through the drive module and produce a series of signals so the module can track the rotation of the motor and the opening position of the valve. EGR Valve The EGR Valve poppet stem is positioned by a three-phase motor. The armature of the motor has twelve permanent magnet segments alternating as north or south poles of a magnet. The armature is surrounded by nine field coils divided into three sets or phases. Each phase has three coils wired in parallel and spaced 120° apart around the motor armature. One lead of each coil set is connected to the respective motor circuit on the drive module.

The other leads from all of the nine coils are joined together. Drive Module Operation The direction of current flow through the coil sets is controlled by the EGR Drive Module. When the integrated circuit in the module connects one coil set to ground, and one of the other two coil sets to a Pulse Width Modulated (PWM) power source, the magnetic fields created by the coils oppose the armature magnetic fields and a controlled rotation of the armature occurs. 37 International ® VT 275 V6 Engine