ELECTRONIC CONTROL SYSTEM X3-28 X3-29 X1-19 CKPO X3-5 X1 X1 2 3 X1 X2 X1 X2 X1-24 CMPO X3-10 X2-6 CAN 2 (+) X3-30 X2 X2 ENGINE IN-LINE 12-WAY CONNECTOR X3 X3 X2-13 CAN 2 (-) X3-12 CAN 1 (+) X3-31 X3 X3 X4 X4 X3-13 CAN 1 (-) X4-20 ATA (+) X4-21 ATA (-) IDM ECM TO TRANS CONTROLLER D 4 3 F C EGR DRIVE MODULE CONNECTOR G EGR DRIVE MODULE 9-WAY DIAGNOSTIC CONNECTOR ECM/IDM Communications The ECM and IDM communicate over three independent communi- cation links. The three links are CMPO, CKPO, and CAN 2. In addition to communications with the IDM, the ECM also sends engine information over the CAN 1 link to the vehicle's instrument cluster and the 9-pin Diagnostic connector.
translates those messages and then commands the EGR valve motor. The EGR drive module monitors the valve action and communicates any faults back to the ECM over the CAN 2 link. crankshaft position and speed to the IDM. The CKPO signal is a square wave signal derived from the information contained in the crankshaft position sensor's AC voltage signal. The ECM generates the CKPO signal by pulling down (switching to ground) a single wire 12V circuit that originates in the IDM. CKPO is used by the IDM for injector timing and fuel quantity calculations. Cam Position Output (CMPO) The CMPO signal is a 0-12V digital signal used to communicate the camshaft position to the IDM.
The CMPO signal is a square wave signal derived from the information contained in the camshaft position sensor's AC voltage signal. The ECM generates the CMPO signal by pulling down (switching to ground) a single wire 12V circuit that originates in the IDM. The IDM reads the signal and uses it for injector timing calculations. CAN 2 The engine CAN 2 link is a two- wire, bi-directional communication circuit between the ECM and IDM and the ECM and the EGR Drive Module. The ECM and IDM use the link to share operating strategies, sensor information, diagnostic demands, and Diagnostic Trouble Codes (DTC).
The ECM also shares desired EGR valve position with the EGR drive module over the CAN 2 link. The EGR Drive Module American Trucking Association (ATA) The ATA link is a 0-5V signal that enables communications between the ECM and the Master- Diagnostics software. The data communication link also allows for programming of the ECM and IDM. Crank Position Output (CKPO) The CKPO signal is a 0-12V digital signal used to communicate the 38 International ® VT 275 V6 Engine