AIR MANAGEMENT SYSTEM Air Filter Restriction Gauge The filter restriction gauge is mounted on the air filter housing. The gauge allows the operator to check the condition without removing the filter. The restriction gauge can be reset by pushing the yellow button on the end. FILTER RESTRICTION GAUGE Note: The filter restriction gauge bellows will lock in position if restriction exceeds 26 inches of water. The filter should be replaced and the gauge reset. The filter element should be replaced if restriction passes 12.5 inches of H 2 O when tested at high-idle, no-load with a magnehelic gauge.
EGR VALVE EGR VALVE Intake Manifold • The intake manifold directs air from the charge air cooler to the intake ports in the cylinder heads. The manifold also provides an internal passage for exhaust gases from the EGR cooler to reach the EGR valve. Exhaust gas will flow into the intake manifold and mix with the intake charge when the EGR valve is open and the exhaust backpressure is higher than the boost pressure. INTAKE MANIFOLD INTAKE MANIFOLD The manifold has an additional internal passage for coolant from the EGR cooler to return to the front cover. 42 International ® VT 275 V6 Engine