AIR MANAGEMENT SYSTEM PNEUMATIC PNEUMATIC TO CAC TO CAC FROM AIR FILTER FROM AIR FILTER ACTUATOR ACTUATOR LOW PRESSURE LOW PRESSURE COMPRESSOR COMPRESSOR HIGH PRESSURE HIGH PRESSURE TURBINE HOUSING TURBINE HOUSING HOUSING HOUSING LOW PRESSURE LOW PRESSURE HOUSING HOUSING TURBINE TURBINE HIGH PRESSURE HIGH PRESSURE COMPRESSOR HOUSING COMPRESSOR HOUSING EXHAUST INLET TO EXHAUST INLET TO HIGH PRESSURE TURBINE HIGH PRESSURE TURBINE EXHAUST OUTLET EXHAUST OUTLET Two-Stage Regulated Turbocharger The dual turbocharger consists of two turbochargers in series. The high pressure turbocharger is the smaller unit and is configured to provide boost at low speeds and loads.
The low pressure turbo is the larger turbocharger and is configured to provide boost at higher speeds and loads. Intake Flow Fresh airflow starts at the inlet of the low-pressure compressor housing, flows from the low- pressure compressor to the high- pressure compressor inlet and then exits directly to the charge air cooler piping. open the bypass valve and divert some of the excess gas flow directly to the low pressure turbine. The high pressure turbocharger results in improved response and higher low speed boost capability providing improved low speed engine torque.
The compounding capability of the two turbos in the mid range results in increased power, fuel efficiency and the ability to maintain power at higher altitudes. The larger compressor is capable of providing the airflow requirement without sacrificing the efficiency of the engine. Operation During operation, the high pressure turbo provides most of the boost at low speeds and light loads. as speed and load increases the low pressure turbo begins to provide the increased airflow. Exhaust Flow Exhaust flow from the cylinders enters the turbine housing of the high-pressure turbocharger and causes the high-pressure turbine and compressor wheel to spin.
Exhaust then exits the high- pressure turbo and enters the low- pressure turbine housing, causing the low-pressure turbine and compressor to spin. Under certain conditions the ECM can modify the air flow through the turbocharger by commanding the boost control solenoid (BCS) closed. When the BCS is closed, boost pressure builds in the pneumatic actuator, and when boost is sufficient, the actuator will 43 International ® VT 275 V6 Engine