FUEL SUPPLY SYSTEM Secondary Fuel Filter • The secondary filter is a top-loaded, engine-mounted fuel filter. Fuel enters the filter housing under pressure from the fuel pump through the inlet line and banjo bolt. Fuel passes through the 4-micron filter element and through the filter stand pipe to enter the two fuel lines to the cylinder heads. FILTER ELEMENT FILTER ELEMENT The filter standpipe contains a valve that is opened by the filter when it is installed in the housing. Without the filter in place, sufficient fuel will not pass through the system for correct engine operation.
FILTER HOUSING Fuel Pressure Regulator Valve The fuel pressure regulator is located between the fuel filter housing and the oil filter housing. Fuel pressure pushes the regulator piston against the regulator spring. When fuel pressure exceeds 45 psi, the regulator begins to open and fuel passes back to the horizontal fuel conditioning module. REGULATOR PISTON REGULATOR PISTON AIR BLEED HOLE AIR BLEED HOLE INLET BANJO INLET BANJO BOLT BOLT FUEL RETURN FUEL RETURN The fuel filter housing contains an air bleed to allow any air in the system to pass back to the fuel tank.
HEADS HEADS REGULATOR SPRING REGULATOR SPRING FUEL TO CYLINDER FUEL TO CYLINDER Fuel Inlet Check Valves • Fuel passing through the filter enters steel lines that lead to the right and left bank cylinder heads. Each line is attached to the cylinder head with a banjo bolt that contains a one-way check valve and a small orifice. The orifice and check valve minimizes pressure pulses in the fuel rail, resulting in smoother delivery of fuel to the injectors. Each fuel line fitting is sealed to the cylinder head by two copper gaskets that must be replaced if the bolt is removed. BANJO BOLT International ® VT 275 V6 Engine 51