FUEL SUPPLY SYSTEM Horizontal Fuel Conditioning Module (HFCM) • The HFCM is chassis mounted on CF500 and CF600 trucks. The module is mounted on the inside of the left frame rail behind the cab. The module is mounted with the cover/mount facing the rail. The module contains the fuel pump, fuel filter, WIF sensor, heater and the recirculation control valve. The water drain valve and all fuel connections are mounted on the module cover. The lower connection on the pump end of the module is the suction side to the tank and the lower connection on the filter side is pressure to the engine-mounted filter. The drain valve is accessible through a hole in the frame rail.
COVER COVER SECONDARY SECONDARY PRESSURE TO PRESSURE TO WIF WIF CONNECTOR CONNECTOR FILTER FILTER DRAIN PLUG DRAIN PLUG PUMP CONNECTOR PUMP CONNECTOR SUCTION SIDE SUCTION SIDE RECIRCULATION RECIRCULATION CONTROL VALVE CONTROL VALVE FUEL PUMP FUEL PUMP Primary Fuel Filter and Fuel Heater • The HFCM contains a 10-micron primary fuel filter. The replaceable filter element opens a fuel passage in the end of the pump when the filter is inserted into the housing. Without the filter in place, sufficient fuel will not pass through the system for correct engine operation. FILTER FILTER Fuel from the tank is exposed to the electric fuel heater as it enters the HFCM module.
The heater is controlled by the key switch start/run circuit and is self- regulating. The heater comes on when fuel temperature is below 50°F (10°C) and goes off at 80°F (27°C). Return fuel from the engine is recirculated to the suction side of the filter until the fuel temperature is sufficient to cause the recirculation valve to close. After the valve closes, all returned fuel is directed back to the tank. HEATER HEATER HEATER CONNECTOR HEATER CONNECTOR 50 International ® VT 275 V6 Engine