FUEL SUPPLY SYSTEM Secondary fuel filter Unfiltered fuel from the fuel tank Conditioned fuel from HFCM to fuel filter Conditioned fuel from fuel filter Fuel pressure test port Fuel return from engine to HFCM Cylinder heads Fuel return to tank Fuel injectors Primary fuel filter Fuel supply to HFCM Drilled passage Drilled passage Fuel supply to engine HFCM Check valve in banjo bolt Check valve in banjo bolt Fuel tank System Operation • The fuel pump, fuel heater, pressure relief valve, Water-in-Fuel (WIF) sensor, recirculation valve, water drain and primary filter are all located in the Horizontal Fuel Conditioning Module (HFCM).
The secondary filter, pressure regulator and banjo bolts are mounted on the engine. through individual steel lines to the cylinder heads. Each line is attached to the cylinder head with a banjo bolt. Each bolt contains an orifice and a check valve. Once in the head passages, fuel is distributed to the injectors. Fuel is exposed to the pressure regulator in the secondary filter housing. The regulator returns excess fuel to the HFCM where it is directed to either the fuel tank or the pump inlet, depending on fuel temperature. The ECM uses the fuel pump relay to activate the fuel pump at key-on.
Fuel drawn from the tank contacts the electric fuel heater, passes through the one-way check valve, and enters the filter where water is separated. Fuel passes through the filter media and enters the pump inlet while water settles to the bottom of the housing until the level of water activates the WIF sensor. Pressurized fuel from the pump is routed to the engine-mounted filter. Fuel flows through the filter, then Both filter elements push open a fuel passage valve when inserted into their respective housings. Without the filter in place, fuel will not flow through the system. The engine could start without the filter, but will not run properly. 49 International ® VT 275 V6 Engine