FUEL MANAGEMENT SYSTEM FUEL MANAGEMENT SYSTEM IDM ECM CMP CKP EOPS MAP INJECTION CONTROL PRESSURE (ICP) SYSTEM APS / IVS LUBRICATION SYSTEM MAF / IAT BAP FUEL SUPPLY SYSTEM ECT MAT EOT High-pressure oil Fuel Electronic circuit Lube oil pressure ICP EGR DRIVE MODULE System Operation The high-pressure oil system is composed of the reservoir, high- pressure pump, injection pressure regulator, rear branch tube, case-to- head tubes, high-pressure rails and the injection control pressure sensor. The high-pressure rails are mounted above the injectors. Oil from the pump enters each rail through a case-to-head tube and a check valve built into the port plug.
Oil from the rail can then enter the top of the injector. When the spool valve closes, pressure pushing on the intensifier piston is vented. With pressure on the plunger relieved, injection stops and low-pressure fuel from the fuel supply system refills the barrel and plunger area of the injector. • The crankshaft driven lube oil pump supplies the reservoir. The reservoir stores the oil under low-pressure to supply the high-pressure pump. The Vee-configured, four-piston high- pressure pump is mounted at the rear of the crankcase Vee and is driven off the rear gear train. The pump is a positive displacement pump capable of high-pressures.
Oil discharged by the pump enters the rear branch tube. The branch tube serves to transfer the oil to the case-to-head tubes. As each injector spool valve opens, oil pushes the intensifier piston down, pressurizing the fuel below the plunger. Fuel pressure acts on the bevel of the nozzle needle. When the force on the needle exceeds the Valve Opening-Spring Pressure (VOP) the needle lifts and forces fuel into the combustion chamber. • The ICP sensor allows the ECM to monitor the injection control pressure. The ECM commands the injection pressure regulator to vary the pressure according to operating conditions. 53 International ® VT 275 V6 Engine