FUEL MANAGEMENT SYSTEM Oil Reservoir • The reservoir for the high-pressure pump is cast into the front of the crankcase Vee. The reservoir receives oil under pressure from the crankshaft driven lube oil pump. The reservoir holds approximately one quart (one liter) of oil. RESERVOIR SCREEN HIGH PRESSURE PUMP RESERVOIR A raised cavity in the bottom of the reservoir feeds oil from the reservoir to the high-pressure pump. A 150-micron screen in the oil reservoir filters any large debris that may be in the oil before it reaches the pump. High Pressure Pump The high-pressure pump produces the injection control pressure.
The pump is mounted under the pump cover at the rear of the crankcase and has four pistons arranged in a Vee configuration. The pump is gear driven off the camshaft gear. The pump aligns with an O-ring sealed passage that leads to the reservoir. Pump output is directed to the branch tube assembly through a quick disconnect adapter. The pump, which protrudes through the top of the pump cover, is sealed at the cover opening with an O-ring. HIGH PRESSURE PUMP HIGH PRESSURE PUMP Injection Pressure Regulator • The Injection Pressure Regulator (IPR) mounts on the high-pressure pump.
HIGH PRESSURE PUMP HIGH PRESSURE PUMP The pump moves more oil than the system requires, so excess oil is drained from the system to control the pressure. The ECM commands the IPR in order to increase or decrease the amount of oil drained from the system. The IPR coil swivels on the IPR so the connection can be positioned pointing down after the IPR is tightened. INJECTION PRESSURE REGULATOR INJECTION PRESSURE REGULATOR PUMP COVER HIGH PRESSURE HIGH PRESSURE PUMP COVER 54 International ® VT 275 V6 Engine