FUEL MANAGEMENT SYSTEM Injection Control Pressure Sensor The Injection Control Pressure (ICP) sensor mounts on the right bank high- pressure rail but protrudes through the valve cover and is accessible without removing the valve cover. RIGHT BANK VALVE COVER The sensor measures pressure in the rail and produces a signal that is sent to the ECM. The ICP sensor is the feedback device for the operation of the IPR. The ECM constantly checks the pressure to determine if the system is performing correctly. When the ECM detects variations, the IPR command is corrected to achieve the desired results. ICP SENSOR High Pressure Oil Rail • A high-pressure rail is mounted over each bank of injectors.
The rail serves as a reservoir of high-pressure oil for use by the injectors. The rail is connected to each injector with a short tube that fits through the injector O-ring. The tubes have the ability to swivel to align with the injector openings. REAR PORT PLUG REAR PORT PLUG The rail does not need to be drained before removal. FRONT PORT PLUG ICP SENSOR HIGH PRESSURE RAIL Port Plugs and Tubes There is one O-ring sealed case-to-head tube assembly for each bank of cylinders. The case-to-head tube connects the branch tube assembly in the tappet area to the rail through the rear port plug.
The rear port plug contains a one-way check valve that dampens pressure pulsations caused by injector operation. REAR PORT PLUG & CHECK VALVES FRONT PORT PLUG The front port plug is used to block oil from leaking into the valve train area. Both port plugs must be in place for the engine to build ICP sufficient to start the engine. International ® VT 275 V6 Engine 55