INJECTOR OPERATION End of injection When the injector drive module determines that the correct amount of fuel has been delivered, it sends a current to the close-coil of the injector. The spool valve closes, and high pressure oil flow into the injector stops. Oil above the intensifier piston flows past the spool valve through the exhaust ports out into the valve cover area. The intensifier piston and plunger return under spring pressure to the fill position. Fuel pressure under the plunger decreases until the nozzle needle control spring forces the needle back onto its seat and injection stops.
Oil Pressure High Pressure Oil Atmosphereic Pressure Fuel Pressure Fuel Supply Pressure Above 3100 PSI OIL INLET OIL INLET Injector Sealing The injector has two replaceable O-rings on the outside of the body. These O-rings seal the fuel inlet area. In addition, the injector has a copper gasket where the nozzle passes through the cylinder head into the combustion chamber. The oil inlet o-ring is contained in the top of the injector. This o-ring can not be replaced. The injector has two coils with a single 4 pin pigtail lead that connects to the valve cover gasket pass-though connecter pigtail.
CONNECTOR O-RING CONNECTOR O-RING O-RINGS O-RINGS NOZZLE NOZZLE GASKET GASKET 59 International ® VT 275 V6 Engine