® UNIQUE REPAIR PROCEDURES Consult service literature for latest information before attempting any repairs Removing Flywheel Adapter The flywheel adapter can be removed using the edge of a heel bar by using the adjacent rear cover bolt for support. The heel bar may also be inserted into the adapter opening and supported on a crankshaft flange bolt to push the adapter off. REAR COVER REAR COVER FLYWHEEL ADAPTER FLYWHEEL ADAPTER HEEL BAR HEEL BAR Removing Seal • Drill two small holes to fit the screw end of a slide hammer. Insert the slide hammer and pull the seal from the rear cover. The new seal is assembled with a wear sleeve.
The wear sleeve must not be removed from the seal prior to installation. MAIN SEAL MAIN SEAL REAR REAR SLIDE SLIDE HAMMER HAMMER REAR COVER REAR COVER 72 International ® VT 275 V6 Engine