UNIQUE REPAIR PROCEDURES Seal Installer Base Place a 360° bead of Loctite® Hydraulic Sealant on the outer circumference of the crankshaft flange. Bolt the base of the rear main seal/wear sleeve installer to the crankshaft. Make sure the crankshaft dowel pin is in the recess provided in the face of the tool. Lubricate the outer diameter of the seal with a 50/50 mixture of soap and water (do not use any other lubricant). Side the seal over the base. BASE BASE SEAL INSTALLER SEAL INSTALLER Installing Seal & Wear Sleeve • Position the rear seal/wear sleeve installer on the base. Place the thrust bearing and drive nut on the threaded shaft.
Tighten the nut until the rear main oil seal bottoms out in the rear oil seal carrier. After the seal bottoms out remove the installer tool and base and install the flywheel adapter, making sure the dowel pin is lined up with the adapter holes. SEAL INSTALLER SEAL INSTALLER Flexplate Bolts • The flexplate bolts are not reusable. Install ten new flexplate bolts. Tighten all bolts in sequence to specification using the torque sequence. Use an alternating pattern across the center to evenly pull down the flexplate. 1 2 5 7 10 10 8 9 6 3 4 International ® VT 275 V6 Engine 73