International Trucks VT 275 — VT275 manual

UNIQUE REPAIR PROCEDURES Rear Cover Removal • Remove the rear cover bolts. Use a rubber hammer to loosen the cover from the crankcase but do not remove. Separate the rear cover from the crankcase gasket and the high-pressure pump cover gasket. COOLANT DRAIN PLUG Caution: Failure to separate the rear cover from the crankcase gasket and pump cover gasket could result in damage to both gaskets. Engine removal and disassembly would be required to replace the lower crankcase gasket. Replacing the pump cover gasket would require the turbocharger, intake manifold and pump cover to be removed.

LOWER CRANKCASE REAR COVER REAR COVER Front Cover Removal • A small quantity of liquid gasket (RTV) is used at the crankcase to lower crankcase joint. Cut the sealant between the gasket and the front cover and between the gasket and the crankcase before removing the cover. FRONT COVER LOWER CRANKCASE Caution: To prevent engine damage cut the sealant where the crankcase and lower crankcase meet when removing the front cover. Failure to adequately cut the sealant prior to remove the front cover or the front cover gasket, could cause the lower crankcase gasket to be pulled out. Complete engine disassembly will be required to replace the crankcase gasket.

Primary Balance Weight Removal • The primary balancer shaft runs within the camshaft and turns the balance counterweight. To remove the counter- weight, remove the 10mm balance shaft counterweight bolt and the three 6mm thrust plate bolts (removal of the third bolt will require rotating the crankshaft to uncover the bolt). The thrust plate fits in a groove cut in the counterweight. The difference between the thickness of the thrust plate and the width of the groove cut in the counterweight determines the primary shaft endplay. The counterweight is timed to the primary balance shaft by a flat on the shaft and a flat on the counterweight.

COUNTERWEIGHT THRUSTPLATE 84 International ® VT 275 V6 Engine