UNIQUE REPAIR PROCEDURES Balance Shaft Removal • The primary balance shaft rides within two bushings in the hollow camshaft. With the rear cover and the counterweight removed, the shaft can be extracted through the rear of the camshaft. The inner camshaft bushings are non-serviceable. CAMSHAFT GEAR PRIMARY PRIMARY BALANCER BALANCER DRIVEN GEAR DRIVEN GEAR Balance Shaft Timing The balance shaft is timed during reassembly by aligning the dot on the balance shaft gear with the dot on the crankshaft flange gear. With the dots aligned, the flex plate pin, the balance shaft gear dot, the flange gear dot and the timing-pin hole will be in a straight line.
TIMING PIN HOLE DOTS FLEX PLATE PIN TIMING Camshaft Timing Camshaft timing is set during assembly. After installing the camshaft and the balance shaft, align the timing pin through the hole in each gear and insert the timing pin tool through the gears until it engages the crankcase hole. Align the dot on the balance shaft with the dot on the face of the crankshaft flange gear as the crankshaft is lowered into the crankcase main bearings. TIMING PIN HOLE With the dots aligned, the flex plate pin, the balance shaft gear dot, the flange gear dot and the timing-pin hole will be in a straight line. TIMING DOTS International ® VT 275 V6 Engine 85