International Trucks VT 275 — VT275 manual

DIAGNOSTIC TESTS* FUEL PRESSURE GAUGE FUEL PRESSURE GAUGE Measure Fuel Pressure • The engine will not perform correctly with low fuel pressure. Fuel pressure can be measured at the secondary filter housing by removing the fuel pressure test port plug and install the ICP System Test Adapter (ZTSE4594). Connect the Fuel Pressure Gauge (ZTSE4681) to the ICP System Test Adapter. Turn the key switch to the ON position and measure the fuel pressure. The following pressure minimums should be met: Cranking 20 psi Idle 50 psi High Idle/No load 50 psi Full load @ rated speed 50 psi If fuel pressure does not meet the minimum, verify there is fuel in the tank and the pump is running.

Then check for fuel aeration, primary and secondary filter condition, pump inlet restriction, pump deadhead pressure, and pressure regulator operation. ICP SYSTEM TEST ADAPTER Check for Fuel Aeration • The engine will not operate correctly with aerated fuel. Aeration can be checked visually using a clear hose and valve. Remove the fuel pressure test port plug. Connect the Fuel Pressure Gauge (ZTSE4681) to the secondary fuel filter housing using the ICP System Test Adapter (ZTSE4594). With the key switch ON, open the valve to allow fuel to flow into a clean container. Observe the fuel flow. Opening the system to install the hose will allow some air to enter the system.

This air will be visible in the fuel flow initially but should clear within a few seconds. If the fuel continues to show signs of aeration, check the suction side of the system for air leaks. *Consult service literature for latest information before attempting any repairs 94 International ® VT 275 V6 Engine