DIAGNOSTIC TESTS Measure Fuel Pump Discharge Pressure Determine the ability of the fuel pump to develop pressure by isolating the fuel pump from the engine-mounted regulator. Remove the banjo bolt on the pressure line at the secondary fuel filter and insert the bolt through the back of the fitting so that the bolt faces away from the engine. Install the Fuel Pressure Test Adapter (ZTSE4696) and tighten the bolt. Attach a 0-160 psi Fuel Pressure Gauge (ZTSE4681) to the test adapter. The fuel pump and its internal pressure regulator are now isolated from the engine-mounted fuel pressure regulator.
FUEL PRESSURE TEST ADAPTER Turn the key switch to the ON position and measure the fuel pressure while the pump is running. Pump discharge pressure should reach 80 psi. If the pressure is low, check for a plugged primary filter and/or high pump inlet restriction. Measure Fuel Inlet Restriction • High inlet restriction can starve the suction side of the fuel pump and cause low fuel pressure. FUEL INLET RESTRICTION ADAPTER With the key switch OFF, remove the water drain plug from the fuel pump. Install the Fuel Inlet Restriction Adapter (ZTSE4698) in place of the plug.
Connect the 0-30 in/hg pressure gauge to the adapter with a shut off valve in the OFF position between the pump and the Fuel Pressure Gauge (ZTSE4681). Turn the key switch ON. With the fuel pump running, open the valve to the 0-30 in/hg pressure gauge and record the restriction. If inlet restriction causes a gauge reading of greater than 6 in/Hg, check the lines from the fuel tank to the pump for restrictions. 95 International ® VT 275 V6 Engine