International Trucks VT 275 — VT275 manual

DIAGNOSTIC TESTS Measure Crankcase Pressure • Crankcase pressure can be used to evaluate the condition of the power cylinders. Remove the oil fill cap and thread the extended Oil Fill Tube (part number 180971C91) into the valve cover fill cap opening. Thread the Crankcase Pressure Test Adapter (ZTSE4510) into the fill adapter. Block off the crankcase breather. By blocking the breather, all of the crankcase gasses are forced through the Crankcase Pressure Test Adapter. Connect the magnehelic gauge to the Crankcase Pressure Test Adapter. Run the engine to reach normal operating temperature (158°F or higher). Run the engine at high idle. Allow the reading to stabilize before taking the reading.

Compare the reading with the performance specifications. Use the Injector Disable test and the Relative Compression test to further evaluate high readings. ICP System Checks • The Injection Control Pressure system must be able to build a minimum of 500 psi during cranking for the engine to start. The possible causes of low ICP during cranking are: Oil rail Oil rail -Faulty ICP sensor -Low oil level in the reservoir -Faulty IPR circuit -ECM not controlling the IPR -Inoperative IPR -Leak in the high-pressure system -Inoperative pump If the ICP is low while cranking, verify the engine has met the minimum cranking lube oil pressure of 20 psi.

Lube oil system pressure is required to maintain the correct level in the reservoir. Inspect the IPR connector for corrosion. Perform the KOEO Standard test. The standard test will verify the IPR circuit. If the circuit has a fault, a 241 DTC will be set. 96 International ® VT 275 V6 Engine Fuel injectors rom low-pressure oil system IC sens Oil reservoir een High- pressure pump IPR valve Check valve Check valve with orifice with orifice Oil drain to sump