Troubleshooting Overview C Series Page TS-4 Section TS - Troubleshooting Symptoms ______________________________________________________________________________________________ ______________________________________________________________________________________________ ______________________________________________________________________________________________ This page can be copied for convenience. Driveability - General Information Driveability is a term that in general describes vehicle performance on the road. Driveability problems for an engine can be caused by several different factors. Some of the factors are engine-related and some are not .
Before troubleshooting, it is important to determine the exact complaint and whether the engine has a real driveability problem or if it simply does not meet driver expectations. The Driveability-Low-Power Customer Complaint Form is a valuable list of questions that must be used to assist the service technician in determining what type of driveability problem the vehicle is experiencing. Complete the checklist before troubleshooting the problem. The form can be found at the end of this section. If an engine is performing to factory specifications but does not meet the customer's expectations, explain to the customer that nothing is wrong with the vehicle and why.
The troubleshooting symptom charts have been set up to divide driveability problems into two different symptoms: Engine Power Output Low and Engine Acceleration or Response Poor. Low power is a term that is used in the field to describe many different performance problems. However, in this manual low power is defined as the inability of the engine to produce the power necessary to move the vehicle at a speed that can be reasonably expected under the given conditions of load, grade, wind, and so on. Low power is usually caused by the lack of fuel flow that can be caused by any of the following factors:
- Lack of full travel of the throttle pedal - Failed boost sensor - Excessive fuel inlet, intake, exhaust, or drainline restriction - Loose fuel pump suction lines. Low power is not the inability of the vehicle to accelerate satisfactorily from a stop or the bottom of a grade. Refer to the Engine Power Output Low troubleshooting symptom tree in Section TS for the proper procedures to locate and correct a low-power problem. The chart starts off with basic items that can cause lower power. Poor acceleration or response is described in this manual as the inability of the vehicle to accelerate satisfactorily from a stop or from the bottom of a grade.
It can also be the lag in acceleration during an attempt to pass or overtake another vehicle at conditions less than rated speed and load. Poor acceleration or response is difficult to troubleshoot since it can be caused by factors such as: - Engine- or pump-related factors - Driver technique - Improper gear shifting - Improper engine application - Worn clutch or clutch linkage. Engine-related poor acceleration or response can be caused by several different factors such as: - Failed boost sensor - Excessive drainline restriction - Throttle deadband.
Refer to the Engine Acceleration or Response Poor troubleshooting symptom tree in Section TS for the proper procedures to locate and correct a poor acceleration or response complaint. For additional information, see Troubleshooting Driveability Complaints, Bulletin Number 3387245. Engine Noise Diagnostic Procedures - General Information NOTE: When diagnosing engine noise problems, make sure that noises caused by accessories, such as the air compressor and power take-off, are not mistaken for engine noises. Remove the accessory drive belts to eliminate noise caused by these units. Noise will also travel to other metal parts not related to the problem.
The use of a stethoscope can help locate an engine noise. Engine noises heard at the crankshaft speed, engine rpm, are noises related to the crankshaft, rods, pistons, and piston pins. Noises heard at the camshaft speed, one-half of the engine rpm, are related to the valve train. A handheld digital tachometer can help determine if the noise is related to components operating at the crankshaft or camshaft speed.