C Series Troubleshooting Overview Section TS - Troubleshooting Symptoms Page TS-11 Air Compressor Noise is Excessive This is symptom tree t006 Cause Correction STEP 1 Carbon buildup is excessive in the air discharge Check for carbon buildup. Replace the air compressor discharge line, if necessary. Check the turbocharger for oil leaks. Check the intake tube for oil. Refer to Procedure 010-033. line, check valve, or cylinder head ............. OK Go To Next Step For all models, check for ice in low spots of the air discharge line, dryer inlet, and elbow fittings. On Holset® models, also check the Econ valve (if equipped). Refer to the OEM service manual.
STEP 2 Ice buildup in the air system components ............. OK Go To Next Step STEP 3 Air compressor mounting hardware is loose, worn, ............. Check air compressor mounting hardware. Refer to Procedure 012-014. or broken OK Go To Next Step STEP 4 Air compressor drive gear or engine gear train is Inspect the drive gears and gear train and repair as necessary. Refer to the Master Repair Manual, Holset® Air Compressors, Bulletin 3666121. worn or damaged ............. OK Go To Next Step STEP 5 Air compressor timing is not correct ............. Check the air compressor timing. Refer to the Master Repair Manual, Holset® Air Compressors, Bulletin 3666121.
OK Go To Next Step STEP 6 Splined drive coupling or gear is excessively worn ............. Check the coupling for wear. Refer to Procedure 012-014. OK Go To Next Step STEP 7 Air compressor is excessively worn or internally Replace or rebuild the air compressor. Refer to the Master Repair Manual, Holset® Air Compressors, Bulletin 3666121. Replace the desiccant element on the Turbo/CR 2000 air dryer (if equipped). Refer to the manufacturer's instructions. ............. damaged OK Go To Next Step STEP 8 Air compressor is sending air pulses into the air ............. Install a ping tank between the air dryer and the wet tank. Refer to the OEM service manual. tanks