Troubleshooting Overview C Series Page TS-12 Section TS - Troubleshooting Symptoms Air Compressor Pumping Excess Lubricating Oil into the Air System This is symptom tree t007 Cause Correction Replace the air compressor air cleaner (if installed). Check the air intake piping. Check engine air intake restriction if the air compressor inlet is plumbed to the vehicle or equipment intake system. Refer to Procedure 010-031. STEP 1 Air intake system restriction to air compressor is ............. excessive OK Go To Next Step STEP 2 E-type system is not plumbed correctly ............. Install an Econ valve, a check valve, and system hoses.
Refer to the Master Repair Manual, Holset® Air Compressors, Bulletin 3666121. OK Go To Next Step STEP 3 Lubricating oil drain line is restricted ............. Remove the air compressor and check the oil drain holes in the air compressor and the accessory drive. Refer to Procedure 012-014. OK Go To Next Step Check for carbon buildup. Replace the air compressor discharge line, if necessary. Check the turbocharger for oil leaks. Check the intake tube for oil. Refer to Procedure 010-033. STEP 4 Carbon buildup is excessive in the air discharge ............. line, check valve, or cylinder head OK Go To Next Step STEP 5 Air compressor runs hot .............
If coolant temperature is above normal, refer to the Coolant Temperature Above Normal - Gradual Overheat symptom tree. OK Go To Next Step STEP 6 Contaminants are building up in the system Drain the reservoirs daily. Refer to the Operation and Maintenance Manual, C Series Engines, Bulletin 4021330. reservoirs ............. OK Go To Next Step STEP 7 Crankcase pressure is excessive ............. Check for excessive blowby. Refer to the Crankcase Gases (Blowby) Excessive symptom tree. OK Go To Next Step STEP 8 Engine angularity during operation exceeds ............. Refer to the Engine Specifications data sheet. specification OK Go To Next Step