Troubleshooting Overview C Series Page TS-16 Section TS - Troubleshooting Symptoms Air Compressor Will Not Stop Pumping This is symptom tree t010 Cause Correction Block the vehicle wheels and check the air system for leaks with spring brakes applied and released. Check for leaks from the air compressor gaskets and the air system hoses, fittings, tanks, and valves. Refer to Procedure 012-019 and the OEM service manual. STEP 1 Air system leaks ............. OK Go To Next Step Check the air governor for correct operation. Make sure the air governor is located less than 0.6 m [2 ft] from the air compressor. Refer to the Master Repair Manual, Holset® Air Compressors, Bulletin 3666121.
STEP 2 Air governor is malfunctioning or not set correctly ............. OK Go To Next Step STEP 3 Unloader valve is malfunctioning ............. Check the unloader valve and unloader body seal. Refer to the Master Repair Manual, Holset® Air Compressors, Bulletin 3666121. OK Go To Next Step STEP 4 Air governor signal line or actuator line is plugged ............. Inspect the signal line and actuator line. Refer to the OEM service manual. OK Go To Next Step Check the operation of check valves, alcohol evaporators, air dryers, and other OEM-installed air system components. Refer to the OEM service manual. STEP 5 Air system component is malfunctioning .............
OK Go To Next Step Inspect the air compressor intake and exhaust valve assemblies. Refer to the Master Repair Manual, Holset® Air Compressors, Bulletin 3666121. STEP 6 Air compressor intake or exhaust valve leaks air .............