C Series Troubleshooting Overview Section TS - Troubleshooting Symptoms Page TS-17 Alternator Not Charging or Insufficient Charging This is symptom tree t013 Cause Correction STEP 1 Voltmeter is malfunctioning ............. Inspect the voltmeter. Replace as needed. Refer to the OEM service manual. OK Go To Next Step Move throttle to raise engine speed to 1200 rpm to excite the alternator. Refer to the Operation and Maintenance Manual Marine C Series, Bulletin 3381968. STEP 2 Engine speed too low for charging ............. OK Go To Next Step STEP 3 Battery cables or connections are loose, broken, or ............. Check the battery cables and connections. Refer to Procedure 013-009.
corroded (excessive resistance) OK Go To Next Step Load-test the battery. If the battery charge is low, charge the battery. If battery fails the second load test, replace the battery. Refer to Procedure 013-007. STEP 4 Battery condition poor ............. OK Go To Next Step Check the alternator belt tension. Check pulleys in belt wrap, and repair, if necessary. Replace belt or belt tensioner, or both. Refer to Procedures 008-002 and 008-080. STEP 5 Alternator belt is loose or missing ............. OK Go To Next Step STEP 6 Alternator pulley is loose on the shaft ............. Tighten the pulley. Refer to Procedure 013-006.
OK Go To Next Step Inspect the alternator mounting hardware for a proper electrical connection to the battery. Remove any paint and debris from the ground connection. Check mounting bracket bolts for proper torque. Refer to Procedure 013-001. STEP 7 Alternator connection to ground is poor ............. OK Go To Next Step STEP 8 Alternator is malfunctioning ............. Test the alternator output. Refer to Procedure 013-001 or OEM service manual if non-Cummins alternator.