Troubleshooting Overview C Series Page TS-28 Section TS - Troubleshooting Symptoms Coolant in the Lubricating Oil This is symptom tree t025 Cause Correction STEP 1 Lubricating oil cooler is leaking ............. Check the lubricating oil cooler for coolant leaks and cracks. Refer to Procedure 007-003. OK Go To Next Step STEP 2 Air compressor cylinder head is cracked or porous, Inspect the air compressor cylinder head and gasket. Refer to Procedure 012-019 or the Master Repair Manual, Holset® Air Compressors, Bulletin 3666121. ............. or has a leaking gasket (nonmarine engines only ) OK Go To Next Step STEP 3 Aftercooler is leaking .............
Inspect and pressure-test the aftercooler for leaks. Refer to Procedure 010-002. OK Go To Next Step STEP 4 Cylinder head gasket is leaking ............. Check the cylinder head gasket. Refer to Procedure 002-004. OK Go To Next Step STEP 5 Cylinder head is cracked or porous ............. Remove intake and exhaust manifolds. Check for evidence of coolant leak. If necessary, operate engine at low idle. Pressure-test the cylinder head. Refer to Procedure 002-004. OK Go To Next Step STEP 6 Cylinder head expansion plugs leaking or ............. Inspect the cylinder head . Refer to Procedure 001-026. misassembled OK Go To Next Step STEP 7 Cylinder liner is cracked or porous .............
Inspect the cylinder liners for cracks and pitting. Refer to Procedure 001-028. OK Go To Next Step STEP 8 Cylinder block is cracked or porous ............. Inspect the cylinder block. Refer to Procedure 001-026.