Cummins — 3666003

Troubleshooting Overview C Series Page TS-30 Section TS - Troubleshooting Symptoms Crankcase Gases (Blowby) Excessive This is symptom tree t027 Cause Correction Check the air compressor engine blow-by contribution. Refer to Procedure 014-010 in Section 14. If blowby contribution is out of specification, rebuild or replace the air compressor. Refer to Procedure 012-014 in Section 12. STEP 1 Air compressor is malfunctioning ............. OK Go To Next Step Check the valve guides for wear. Replace the cylinder head, if necessary. Refer to Procedure 002-004 in Section 2. STEP 2 Cylinder head valve guides are excessively worn ............. OK Go To Next Step Check for air intake system leaks.

Refer to Procedure 010-024 in Section 10. Check the pistons and piston rings for wear or damage. For piston cleaning and reuse; Refer to Procedure 001-043 in Section 1. For cylinder liner inspection and reuse; Refer to Procedure 001-028 in Section 1. For piston ring inspection; Refer to Procedure 001-047 in Section 1. STEP 3 Piston or piston rings are worn or damaged ............. OK Go To Next Step Check the turbocharger compressor and turbine seals. Refer to Procedure 010-033 in Section 10. Check the turbocharger blowby contribution. Refer to Procedure 014-010 in Section 14. If the blowby contribution is out of specification, replace the turbocharger.

Refer to Procedure 010-033 in Section 10. STEP 4 Turbocharger oil seal is leaking .............