Troubleshooting Overview C Series Page TS-40 Section TS - Troubleshooting Symptoms Engine Noise Excessive This is symptom tree t047 When troubleshooting engine noise complaints, make sure the engine accessories (air compressor, fan clutch, freon compressor, or hydraulic pump) are not the cause of the noise. Refer to Engine Noise Diagnostic Procedures - General Information at the end of Section TS before using this symptom tree. Cause Correction STEP 1 Fan drive belt is loose ............. Check the belt tension and tighten if necessary. Refer to Procedure 008-002. OK Go To Next Step STEP 2 Fan is loose, damaged, or not balanced ............. Check the fan. Refer to Procedure 008-042.
OK Go To Next Step STEP 3 Air intake or exhaust leaks ............. Inspect the air intake and exhaust systems for air leaks. Refer to Procedure 010-024. OK Go To Next Step STEP 4 Air intake or exhaust piping is contacting the ............. Inspect the air piping, chassis, and cab for contact points. Refer to the OEM service manual. chassis or cab OK Go To Next Step STEP 5 Lubricating oil level is above or below specification ............. Check the oil level. Add or drain oil, if necessary. Refer to Procedure 007-025. OK Go To Next Step Refer to Cummins Lubricating Oil Recommendations, Bulletin 3810240. If the oil pressure is low, refer to the Lubricating Oil Pressure Low symptom tree.
STEP 6 Lubricating oil is thin or diluted ............. OK Go To Next Step STEP 7 Lubricating oil pressure is below specification ............. Check the oil pressure. If the pressure is low, refer tothe Lubricating Oil Pressure Low symptom tree. OK Go To Next Step STEP 8 Vibration damper is damaged ............. Inspect the vibration damper. Refer to Procedure 001-052. OK Go To Next Step STEP 9 Coolant temperature is above specification ............. Refer to the Coolant Temperature Above Normal - Gradual Overheat symptom tree. OK Go To Next Step