C Series Troubleshooting Overview Section TS - Troubleshooting Symptoms Page TS-41 Engine Noise Excessive This is symptom tree t047 When troubleshooting engine noise complaints, make sure the engine accessories (air compressor, fan clutch, freon compressor, or hydraulic pump) are not the cause of the noise. Refer to Engine Noise Diagnostic Procedures - General Information at the end of Section TS before using this symptom tree. Cause Correction STEP 10 Drivetrain noise is excessive ............. Disconnect the drivetrain. Check for engine noise. Refer to the OEM service manual. OK Go To Next Step STEP 11 Engine mounts are worn, damaged, or not correct ............. Check the engine mounts.
Refer to Procedure 016-010. OK Go To Next Step STEP 12 Overhead adjustments are not correct ............. Measure and adjust the overhead settings. Refer to Procedure 003-004. OK Go To Next Step STEP 13 Overhead components are damaged ............. Inspect the rocker levers, rocker shafts, and valves for damage or excessive wear. Refer to Procedure 003-008. OK Go To Next Step STEP 14 Injector is malfunctioning ............. Perform the single-cylinder cutout test. Replace the injectors as necessary. Refer to Procedure 006-026. OK Go To Next Step STEP 15 Turbocharger noise ............. Refer to the Engine Noise Excessive - Turbocharger symptom tree.
OK Go To Next Step STEP 16 Combustion noise excessive ............. Refer to the Engine Noise Excessive symptom tree. OK Go To Next Step STEP 17 Flywheel or flexplate capscrews are loose or ............. Check the flywheel or flexplate and the mounting capscrews. Refer to Procedure 016-005. broken OK Go To Next Step STEP 18 Torque converter is loose ............. Check the torque converter. Refer to the OEM service manual. OK Go To Next Step