C Series Troubleshooting Overview Section TS - Troubleshooting Symptoms Page TS-43 Engine Noise Excessive — Combustion Knocks This is symptom tree t048 Refer to Engine Noise Diagnostic Procedures - General Information at the end of Section TS before using this symptom tree. Cause Correction STEP 1 Ether starting aid is malfunctioning ............. Repair or replace the ether starting aids. Refer to the OEM instructions. OK Go To Next Step STEP 2 Fuel grade is not correct for the application or the Operate the engine from a tank of high-quality fuel. Refer to Fuel for Cummins Engines, Bulletin 3379001. fuel quality is poor .............
OK Go To Next Step STEP 3 Air in the fuel system ............. Check for air in the fuel system. Vent air from the system. Refer to Procedure 006-024. OK Go To Next Step STEP 4 Coolant temperature is above specification ............. Check the coolant level. Refer to Procedure 008-018. OK Go To Next Step Perform the automated cylinder performance test. Replace injectors as necessary. Refer to Procedure 006-026. STEP 5 Injector is malfunctioning ............. OK Go To Next Step STEP 6 Overhead adjustments are not correct ............. Measure and adjust the overhead settings. Refer to Procedure 003-004.