Cummins — 3666003

Troubleshooting Overview C Series Page TS-46 Section TS - Troubleshooting Symptoms Engine Noise Excessive — Piston This is symptom tree t051 Refer to Engine Noise Diagnostic Procedures - General Information at the end of Section TS before using this symptom tree. Cause Correction STEP 1 Fuel grade is not correct for the application or the Operate the engine from a tank of high-quality fuel. Refer to the Operation and Maintenance Manual, C Series Engines, Bulletin 4021330. fuel quality is poor ............. OK Go To Next Step STEP 2 Injector is malfunctioning ............. Perform the automated cylinder performance test. Replace injectors as necessary. Refer to Procedure 006-026.

OK Go To Next Step STEP 3 Overhead adjustments are not correct ............. Measure and adjust the overhead settings. Refer to Procedure 003-004. OK Go To Next Step STEP 4 Connecting rod is bent or out of alignment ............. Remove and inspect the connecting rods. Refer to Procedure 001-014. OK Go To Next Step STEP 5 Piston or piston rings are worn or damaged ............. Check for air intake system leaks. Check the pistons and piston rings for wear or damage. Refer to Procedure 001-043. OK Go To Next Step STEP 6 Piston pin or bushing is loose, worn, or not ............. Remove the pistons and inspect the piston pin and bushing for damage, wear, and correct installation.

Refer to Procedure 001-043. installed correctly