C Series Troubleshooting Overview Section TS - Troubleshooting Symptoms Page TS-45 Engine Noise Excessive — Main Bearing This is symptom tree t050 Refer to Engine Noise Diagnostic Procedures - General Information at the end of Section TS before using this symptom tree. Cause Correction STEP 1 Lubricating oil pressure is below specification ............. Check the oil pressure. If the pressure is low, refer toProcedure 007-025. OK Go To Next Step Check the oil level. Verify the dipstick calibration and the oil pan capacity. Fill the system to the specified level. Refer to Procedure 007-025. STEP 2 Lubricating oil level is below specification .............
OK Go To Next Step STEP 3 Lubricating oil is thin or diluted ............. Refer to Procedure 007-025. If the oil pressure is low, refer to the Lubricating Oil Pressure Low symptom tree. OK Go To Next Step STEP 4 Main bearing capscrews are loose, worn or not ............. Check the torque on the main bearing capscrews. Inspect the capscrews for wear. Refer to Procedure 001-016. tightened correctly OK Go To Next Step STEP 5 Main bearings are damaged or worn, or the wrong Inspect the main bearings for damage, excessive wear, and the correct part number. Refer to Procedure 001-006. .............
bearings are installed OK Go To Next Step STEP 6 Crankshaft journals are damaged or out of round ............. Inspect the crankshaft journals. Refer to Procedure 001-016.