Troubleshooting Overview C Series Page TS-78 Section TS - Troubleshooting Symptoms Lubricating Oil Pressure High This is symptom tree t104 Cause Correction Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature Below Normal troubleshooting symptom tree. STEP 1 Engine is cold ............. OK Go To Next Step Make sure the correct lubricating oil is being used. Refer to Cummins® Engine Oil Recommendations, Bulletin 3810340. STEP 2 Lubricating oil viscosity not correct ............. OK Go To Next Step STEP 3 Lubricating oil filter is not correct ............. Make sure the correct oil filter is being used.
Refer to the Operation and Maintenance Manual, C Series Engines, Bulletin 4021330. OK Go To Next Step STEP 4 Pressure switch or gauge malfunctioning ............. Install a pressure gauge at main oil rifle. Verify the pressure switch is functioning correctly. Refer to the OEM service manual. OK Go To Next Step Verify that the correct lubricating oil pump and o- rings are installed. Refer to Procedure 007-031 in Section 7. STEP 5 Lubricating oil pump installation not correct ............. OK Go To Next Step STEP 6 Main oil pressure regulator is malfunctioning ............. Replace the main oil pressure regulator assembly. Refer to Procedure 007-029 in Section 7.