Cummins — 3666003

C Series Troubleshooting Overview Section TS - Troubleshooting Symptoms Page TS-79 Lubricating Oil Pressure Low This is symptom tree t105 Cause Correction STEP 1 Pressure switch or gauge malfunctioning ............. Install a pressure gauge at main oil rifle. Verify the pressure switch is functioning correctly. Refer to the OEM service manual. OK Go To Next Step STEP 2 Lubricating oil level is above or below specification ............. Check the oil level. Add or drain oil, if necessary. Refer to Procedure 007-037 (Lubricating Oil System) in Section 7 and Procedure 007-009 (Lubricating Oil Dipstick) in Section 7. OK Go To Next Step Inspect the engine for external oil leaks.

Tighten the capscrews, pipe plugs, and fittings. Replace gaskets, if necessary. Refer to Procedure 007-001 (Engine Oil Heater) in Section 7. Refer to Procedure 007-003 (Lubricating Oil Cooler) in Section 7. Refer to Procedure 007-013 (Lubricating Oil Filter (Spin-On)) in Section 7. Refer to Procedure 007-025 (Lubricating Oil Pan) in Section 7. Refer to Procedure 007-037 (Lubricating Oil System) in Section 7. STEP 3 Lubricating oil leak (external) ............. OK Go To Next Step STEP 4 Lubricating oil filter is not correct ............. Make sure the correct oil filter is being used.

Refer to the Operation and Maintenance Manual, Automotive, Recreational Vehicle, and Transit Bus, C8.3 Series Engines, Bulletin 3810248. OK Go To Next Step STEP 5 Lubricating oil is contaminated with coolant or fuel ............. Refer to the Lubricating Oil Contaminated symptom tree. OK Go To Next Step Change the oil and filters. Refer to Procedure 007-013 (Lubricating Oil Filter (Spin-On)) in Section 7. Refer to Procedure 007-037 (Lubricating Oil System) in Section 7. Use the oil type recommended in Section V of the operation and maintenance manual. STEP 6 Lubricating oil does not meet specifications for .............

operating conditions OK Go To Next Step STEP 7 Engine angularity during operation exceeds specification ............. Refer to to the engine performance curves and data sheet. OK Go To Next Step