Engine Installation C Series Page 0-10 Section 0 - Complete Engine - Group 00 Make sure all lines, hoses, and tubes are correctly routed and fastened to prevent engine damage. CAUTION Align the engine in the chassis and tighten the engine mounting capscrews. Refer to the OEM's torque specifications. Connect all engine and chassis-mounted accessories that were removed. Install and adjust the throttle linkage to the injection pump control lever; refer to the OEM service manual. NOTE: The total oil capacity of the standard engine, including combination full flow and bypass oil filters, is 23.6 liters [6.25 gal]. Fill the engine with clean engine lubricating oil. Refer to Procedure 007-037.
NOTE: The engine lubricating oil system must be pressurized before starting the engine. Fill the cooling system with 50-percent water, 50-percent ethylene glycol-base antifreeze, and proper amount of DCA corrosion protection. Refer to Procedure 008-018. NOTE: The total coolant capacity (engine only ) is 9.9 liters [2.25 gal] for air-aftercooled engines, and 10.9 liters [2.85 gal] for water-aftercooled engines. Refer to the OEM's specifications for radiator and system capacity.