C Series Engine Installation Section 0 - Complete Engine - Group 00 Page 0-11 Make a final inspection to make sure all hoses, wires, linkages, and components have been correctly installed and tightened. Prime the low-pressure fuel system. 1. Open the bleed screw 2. Operate the plunger on the fuel transfer pump until the fuel flowing from the fitting is free of air. 3. Close the bleed screw. Do not remove the pressure cap from a hot engine. Wait until the coolant temperature is below 50°C [120°F] before removing the pressure cap. Heated coolant spray or steam can cause personal injury. WARNING Operate the engine at low idle for 2 to 3 minutes.
Shut off the engine and wait 5 to 7 minutes for the oil to drain to the oil pan. Check the oil and coolant levels. Fill the engine to the correct oil and coolant levels if necessary. Refer to Procedures 007-037 and 008-018.