Engine Storage - Long Term C Series Page 0-14 Section 0 - Complete Engine - Group 00 The engine must be stored in an area that is dry and has uniform temperature. CAUTION Remove any accessory drive belts to prevent localized stretching and deformation. If the engine can be stored inside a designated storage facility isolated from the external environment, ignore the following step. Excluding the crankshaft, ensure that all external dynamic engine components are rotated every 6 weeks. Ensure parts are free from corrosion, debris and water ingress. Record and date this on the engine tag created.
Remove the Engine from Long Term Storage To remove the engine from long term storage, follow the following steps: To reduce the possibility of personal injury, avoid direct contact of hot oil with your skin. CAUTION Flush the engine preservative oil out of the engine by removing the plug from the main engine oil rifle and pumping a hot, lightweight mineral oil through it. Make sure that the engine crankshaft is barred at least three to four revolutions during this flushing procedure. Drain all the mineral oil that was used to flush the engine clean of the engine preservative oil. Install the drain plugs. Install new oil, fuel and coolant filters.
Fill the engine to the high mark with engine oil. If the engine has been in storage for less than 24 months and if the cooling system was drained, fill the cooling system with coolant. Refer to Procedure 018-004 in Section V for antifreeze, water, and SCA specifications. If the engine has been in storage for 24 months, every 24 months the engine cooling system must be drained and flushed with a suitable solvent or a hot, lightweight mineral oil. Fill the cooling system with coolant. Refer to Procedure 018-004 in Section V for antifreeze, water, and SCA specifications.
If the engine has been in storage for less than 24 months and the engine has an extended life coolant with a rust inhibitor, drain the cooling system. Fill the cooling system with coolant. Refer to Procedure 018-004 in Section V for antifreeze, water, and SCA specifications. Adjust the engine brake (if applicable) and valve clearances. Reference the Overhead Set procedure in the corresponding base Troubleshooting and Repair Manual or Service Manual for the engine being serviced. Prime the lubricating system. Tighten the intake and exhaust manifold mounting capscrews. Reinstall any accessory drive belts that were removed. Replace all spark plugs.
Reference the Spark Plugs procedure in the corresponding base Troubleshooting and Repair Manual or Service Manual for engine being serviced(if applicable). Make sure all fuel lines are securely tightened and all fuel shutoff valves are open prior to attempting to start the engine. Start the engine. Note that if might take multiple cranking attempts to start the engine. Do not crank the engine more than 30 seconds at a time as this might cause the starter to overheat and fail.
Note that the engine might run rough until the fuel system is completely primed or until all residual fuel system preservative oil is completely flushed out of the fuel system (if the fuel has been treated with fuel system preservative oil). Install the exhaust aftertreatment components (if applicable). Force an active regeneration (if applicable).